alupex (uponor) pipes with Firetect Wrap

aluPE-X pipes with pipe wrap

Fire rated Firetect solution:

  • alupex (uponor) pipes:
    – Ø 16mm up to Ø 75mm
    – including non-insulated + insulated pipes: pipe insulation Armaflex 13mm
    – also tested in PA board + fire rated mortar
  • always the right size on the job:
    – Wrap also available as Wrap-‘n-roll (roll 18 m)
  • minimum material usage with Wrap-‘n-roll:
    – 1 layer for pipes Ø 75mm in mortar
    – 2 layers for pipes Ø16 up to Ø 75mm in PA board

  • constructive element:
    – flexible walls ≥ 100mm
    – rigid walls ≥ 100mm
  • fire resistance: EI 60 up to EI 90, depending on configuration + application

 
Also view:
– other Firetect solutions within application fire rated alupex (uponor) pipes
– Field of Application within Firetect system: fire rated alupex pipes (PDF)
 
 
 
General instructions for Firetect Wrap

  • application always acc. DoP No. CPR-14/0251-wrap
  • standard application on 2 sides:
    – Wrap: wrap tight-fit around pipe; hold in position with tape during installation
    – Wrap-‘n-roll: cut to size; see table in TDS
    – wrap required layers tight-fit around pipe; if necessary, hold in position with tape during installation
  • slide into place, flush with constructive element, yet still visible
  • apply smoke seal with Firetect Acrylic or Firetect PA sealer on either side
TOP